JLG 10MSP Service Manual - Manual (Page 88)

SECTION 5 - MAST COMPONENTS
5-6 – JLG Lift – 3121228
5.7 MAST ASSEMBLY INSTALL/REMOVE
Mast Removal
The following components must be removed from the
machine before removing the mast assembly:
With Platform Elevated (approx. 4 ft. (1.2m)) Remove;
• Front Hood (See Section 3.2)
• Drive Motors Cover (See Section 3.2))
• Platform/Material Tray Assembly (See Section 5.3) -
Remove the bottom bolts and unhook the enable foot
switch and entry gate interlock wire harness from the
platform junction box.
With Platform Completely Lowered - (If necessary, use
Manual Descent Valve) Remove;
• Platform Control Console (See Section 4.2)
• Mast Cover (See Section 5.2)
• Platform/Material Tray Assembly (See Section 5.3)
• Battery Charger Assembly (See Section 3.7)
1. Unplug the platform control cable (P4) connector at
the ground control module.
2. Unplug and remove the amber beacon mounted on
the front of the mast assembly.
Step 4. Gently push hose assembly into coupling
body (see directional arrow).
Step 5. While maintaining slight pressure on the
hose assembly, actuate the tool (see arrow).
Step 6. Pull on hose assembly to complete discon-
nection.
Mast Assembly Mounting Bolt Location
1. Mast Mounting Column (a)
2. Mounting Bolt/Washer/Nut Locations (b)
Notes: (a) Battery charger removed.
(b) Apply Loctite #271 to bolt threads on final
assembly.
1
2