Rear bumper cover - installation, Drive motor cover - installation – JLG 10MSP Service Manual User Manual

Page 35

SECTION 3 - BASE COMPONENTS

3121228

– JLG Lift –

3-3

Rear Bumper Cover - Installation

Five (5) of the Drive Motor cover screws must be removed
to remove the rear bumper cover, see the Drive Motor
Cover - Installation illustration. To gain access to those
screws, elevate the platform.

Drive Motor Cover - Installation

NEVER WORK UNDER AN ELEVATED PLATFORM UNTIL THE
PLATFORM HAS BEEN SAFELY RESTRAINED FROM ANY MOVE-
MENT BY BLOCKING OR OVERHEAD SLING.

To gain access to the drive motor cover and screws, ele-
vate the platform.

Rear Bumper Cover Installation

1. Bumper Cover
2. Screws/Washers

3. AC Input - Receptacle

Assembly Cover

Drive Motor Cover Installation

1. Cover
2. Screws/Washers (a)

3. Platform Stop (a) (b)
4. U-Style Tapped Nuts

NOTE: (a) Apply Loctite #242 to threads before tightening.

(b) Height of the platform stops is set by installing two
(2) 5/16" dia. wide plain steel flatwashers under the head
of each stop, tighten securely.