Input carrier disassembly, Input carrier disassembly -12 – JLG 10MSP Service Manual User Manual

Page 44

SECTION 3 - BASE COMPONENTS

3-12

– JLG Lift –

3121228

Input Carrier Disassembly

1. Remove Retaining Rings (G18) from each of the

three Planet Shafts (G6).

NOTE: Do not overstress these Retaining Rings when removing

them.

2. Remove Thrust Plate (G23).

3. Remove Thrust Washer (G25) from each Planet

Shaft (G6).

4. Slide each Input Planet Gear (G5) off the Planet

Shaft (G6).

5. Press out Bushing (G26) from the bore of each

Planet Gear (G5). Bushings cannot be reused
when removed.

6. Remove the other Thrust Washer (G25) from each

Planet Shaft (G6).

7. Remove Retaining Ring (G24) from Output Sun

Gear (G8).

8. Slide Output Sun Gear (G8) out from the center of

the Input Carrier (G7).

9. Remove the three Planet Shafts (G6) from the Input

Carrier.

NOTE: The Planet Shafts (G6) are held in with a press fit. To avoid

damage to the parts, use an arbor or hydraulic press to
remove the Planet Shafts (G6).

Input Carrier Disassembly