JLG TF6-42 (9150-4003) Operator Manual - Manual (Page 84)

P8.0
PLATFORM CONTROLS AND INDICATORS
1234
1234
1234
1234
Controls and Indicators
This machine is equipped with a work platform. The intended purpose is to
position personnel with their tools and supplies at positions above ground
level, and can be used to reach work areas located above machinery or
equipment.
The platform has an operator Control Station. From this control station, the
operator can drive and steer the machine in both forward and reverse directions.
The operator can raise or lower the boom or rotate the platform left or right.
The lift is not intended to be used to lift material other than supplies which
personnel in the platform require to do their job. Supplies or tools which extend
outside the platform are prohibited unless written approval has been obtained
through JLG/Gradall. It must not be used as a forklift, crane, support for
overhead structure, or to push or pull another object.
The speeds of boom functions are variable from zero to maximum speed
depending upon the position of the function speed control. Functions controlled
by toggle switches are either on or off. A foot operated switch in the platform
must be depressed before any controls will function and provides a means of
emergency stop when the operators foot is removed from the footswitch.
The unrestricted capacity of the lift is 500 lbs. (230 kg). This means that with
a platform load of 500 lbs. (230 kg) or less, the platform may be positioned
anywhere the boom will reach, with the machine level and on a smooth, firm,
and level surface and tires properly inflated.
STEER
SELECT
PLATFORM
LEVELING
OVERRIDE HORN
POWER/
EMERGENCY
STOP LIGHTS
BOOM CONTROL
JOYSTICK
FUNCTION
SPEED
PLATFORM
ROTATE
SWAY
DRIVE/
STEER
CAPACITY
INDICATOR
ENABLE
INDICATOR
TILT
INDICATOR
CREEP
INDICATOR
Boom
In
Boom Up
Boom Down
Boom
Out
ENGINE
START/
AUX POWER