JLG TF6-42 (9150-4003) Operator Manual - Manual (Page 75)

Form No. 20140, Issued 3/03 z z z z z Transformer Series Work Platform Manual
P5.0
WORK PLATFORM INSTALLATION
Attachment Operation
Operate a handler equipped with the personnel work platform as a partially-
loaded handler. Pay special attention to capacity and range limits for the handler/
platform combination in use.
Practice operation of handler and personnel work platform in a safe, open area,
not hazardous to yourself, platform occupant(s), equipment or property. Become
thoroughly familiar with response of handler and attachment to controls before
operating in a work situation.
Perform all “Checks Before Operating Platform” as identified on page P6.0.
Approved Attachments
The Transformer Series Work Platform With Controls has been approved
for use with JLG/Gradall Transformer Series Material Handlers. Several
other JLG/GRADALL-approved attachments are available for use with your
material handler. Contact your JLG/GRADALL Material Handler Distributor for
information on approved attachments designed for special material handling
situations.
The machine serial number plate lists attachments approved for use with your
handler. However, there may be additional approved attachments available.
Contact your JLG/GRADALL Material Handler Distributor for further information.
Non-Approved Attachments
Do not use slip-on fork mounted personnel work platforms. Only JLG/
Gradall manufactured personnel work platforms are approved for use with the
JLG/Gradall Material Handler.
Do not attach any type of work platform that is not manufactured by
JLG/Gradall to the Quick Switch™ adapter support.
Do not use non-approved attachments for the following reasons:
• JLG/GRADALL cannot establish range and capacity limitations for “will fit”,
homemade, altered, or other non-approved attachments.
• An overextended or overloaded handler can tip over with little or no warning
and cause serious injury or death to the operator, platform occupants, and/
or those working near the handler.
• JLG/GRADALL cannot assure the ability of a non-approved attachment to
perform its intended function safely.
• Non-approved attachments may cause structural or other damage to the
handler. Such damage could cause dangerous operating conditions resulting
in serious injury or death.
Attachments which have not been
approved for use with your material
handler could cause machine
damage or an accident resulting in
injury or death.
Never use an attachment without
the appropriate, JLG/GRADALL
supplied capacity chart for that
particular attachment installed on
the handler.
WARNING !
Fork mounted personnel work
platforms are not approved for use
on any JLG/Gradall Material
Handlers.
WARNING !
WARNING !