JLG TF6-42 (9150-4003) Operator Manual - Manual (Page 48)

LOADING & SECURING FOR TRANSPORT
17.0
WARNING !
Before loading handler for
transport, make sure deck, ramps
and handler wheels are free of
mud, snow and ice. Failure to do
so could cause handler to slide,
resulting in an accident causing
serious injury or death.
Loading & Securing Handler For Transport
1. Level the material handler prior to loading.
2. Using a spotter, load the handler with boom as low as possible to keep a low
center of gravity.
3. Once loaded, apply parking brake and lower boom until boom or attachment
is resting on deck. Move all controls to “Neutral”, stop engine and remove
the control station selector key.
4. Secure machine to deck by passing chains through four tie-down lugs on
front and rear of machine. (See figures 15-1 & 15-2)
5. Secure work platform by passing restraining strap through center as shown
in figure 15-3.
6. Do not tie down front of boom.
Figure 15-1 (front view) Figure 15 -2 (rear view)
Figure 15 -3 (work platform view)