JLG 10MSP Operator Manual - Manual (Page 84)

SECTION 5 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
5-10 – JLG Lift – 3121227
5.6 GROUND CONTROL STATION -
PROGRAMMING
General
The Ground Control Station on the MSP10 machine allows on-
board programming of various component and control function
personality settings.
Programming may be required under circumstances such as:
• The Ground Control Station module has been replaced and
optional equipment on the machine needs to be enabled.
• Optional equipment has been added to the machine in the
field and a function must be enabled before operation.
• Customizing the machine to fit a specific application, such as
changing the LCD display language.
Programming Levels
There is one (1) password protected programming level available
to the Operator:
• Level-3: Operator’s Settings - Level-3 Password: 33271
Operator Programming Mode
In the Operator Level Programming Mode the following items are
shown on the main menu:
• Tilt Sensor
• Program
Tilt Sensor
Allows viewing current tilt sensor - individual X and Y direction
degree reading.