JLG 10MSP Operator Manual - Manual (Page 58)

SECTION 3 - MACHINE OPERATION
3-30 – JLG Lift – 3121227
3.12 TRANSPORTING, LIFTING AND TIE-DOWN
PROCEDURES
General
The 10MSP Lift may be transported to a work site using the follow-
ing methods:
• Driving the machine around on its base wheels if travel sur-
face area permits.
• Moved with a fork-lift truck using the fork-lift pockets in the
base frame. (See Figure 3-12.)
• Loaded onto a transport vehicle and driven to the work site,
when equipped with Front and Rear Tie-Down Loop. (See
Figure 3-13.)
Fork-Lift Truck Transport
10MSP Model Lifts are equipped with fork-lift pockets running
crossways under the base frame. This allows the machine to be
either transported around a work area or lifted onto a higher level
using a standard fork-lift truck.
NOTE: Fork-lift trucks must be capable of handling the gross
weight of the machine, see the Operating Specifications
table at the beginning of this Section.
Figure 3-12. Forklift Truck Lifting Pockets.
1. Fork Lift Pockets
1