JLG 10MSP Operator Manual - Manual (Page 66)

SECTION 3 - MACHINE OPERATION
3-38 – JLG Lift – 3121227
Removing a Rug
This section describes the use of the Rug Carrier accessory in
removing a rug from a horizontal pivoting arm display rack.
1. Select the intended location in the display for removal of the
rug. Open the display rack to provide adequate space for the
lift and rug.
2. With the Rug Carrier Accessory arms stowed, drive the lift
into position prior to loading the rug.
3. Swing and lock the Rug Carrier Accessory arms into the
carry position.
4. Elevate the platform a few feet. Start to roll the rug onto the
Rug Carrier Accessory arms.
5. Be certain the rug is centered over its length on the Rug Car-
rier Accessory.
6. While elevating to the required height for removing the rug
from the display arm, continue to roll the rug until it is com-
pletely rolled up on the carrier arms.
7. Properly remove the rug from the display arm. Never climb
onto the platform rails for any reason.
8. After adequately removing the rug from the display arm,
lower the platform.
9. Remove the rug from the Rug Carrier Accessory. If required,
use an assistant to unload the rug from the Rug Carrier
Accessory Arms.
10. Replace the Rug Hanger Accessory arms to the stowed posi-
tion for normal operation.
Removing Rug From Display Arm.
1. Roll Rug onto Rug Carrier while Elevating Platform
2. Rug Carrier in Carry Position
1
2