JLG 10MSP Operator Manual - Manual (Page 18)

SECTION 1 - SAFETY PRECAUTIONS
1-8 – JLG Lift – 3121227
• Keep non-operating personnel at least 6 ft. (1.8m) away
from machine during all driving operations.
• Limit travel speed according to conditions of ground sur-
face, congestion, visibility, slope, location of personnel,
and other factors causing hazards of collision or injury to
personnel.
• Be aware of stopping distances in all drive speeds.
• Do not drive at high speeds in restricted or close quarters
or when driving in reverse.
• Exercise extreme caution at all times to prevent obstacles
from striking or interfering with operating controls and per-
sons in the platform.
• Ensure that operators of other overhead and floor level
machines are aware of the aerial work platform’s pres-
ence. Disconnect power to overhead cranes.
• Warn personnel not to work, stand, or walk under a raised
platform. Position barricades on floor as necessary.
1.4 LIFTING, AND HAULING
General
• Never allow personnel in platform while lifting, or hauling.
• This machine should not be towed in the event of emer-
gency, malfunction, power failure, or loading/unloading.
Lift only with a fork lift truck using the designated fork lift
pockets in the machine’s base frame.
• Ensure platform is fully retracted and completely empty of
tools prior to lifting or hauling.
• When lifting machine with a forklift, position forks only at
designated areas of the machine. Lift with a forklift of ade-
quate capacity.
• Refer to the Machine Operation section of this manual for
lifting information.