JLG SSV10 Service Manual - Manual (Page 72)

SECTION 4 - CONTROL COMPONENTS
4-18 – JLG Lift – 3121187
E-Stop/ShutDown Switch - Install/Remove Joystick Assembly - Install/Remove
Platform Console - E-Stop Switch Installation
1. Loosen Switch Set Screw
2. Turn Switch 90°
3. Pull Spring-Loaded
Release Lever Out
4. Remove Barrel Assembly
5. Barrel Seal
6. Switch to Body Retainer
Hooks (a)
7. Switch Retainer Slots
Note: (a) Use a small straight blade screwdriver to extend the
spring-loaded retainer hooks (6) out and release the
switch from the body.
1
2
4 5
3
7
6
Platform Console - Joystick Installation
1. Joystick Assembly
2. Attach Screws (Qty.-4)
3. Nylon Washers (Qty.-4) 4. Rubber Boot/Gasket
5. Install/Remove through the
Access Hole in Bottom of
Housing. (a) (b)
Note: (a) Remove the console mounting bracket.
(b) Remove the key switch and e-stop switch to remove
joystick assembly through access hole in bottom of con-
sole.
2
3
4
5
1