JLG SSV10 Service Manual User Manual

Page 62

Text mode
Original mode

SECTION 4 - CONTROL COMPONENTS

4-8

– JLG Lift –

3121187

IMPORTANT

THE MAIN CIRCUIT BOARD AND THE SMALLER LCD CIRCUIT
BOARD MOUNTED TO THE COVER ASSEMBLY, ARE CON-
NECTED BY A RIBBON CABLE. REMOVE THE COVER CARE-
FULLY ONCE THE COVER SCREWS ARE REMOVED FROM THE
BACK OF THE MODULE.

Cover Installation

1. Remove the (6) Hex Socket Screws from the Heat Sink/
Base. One screw is under the Warranty/Tamper Label.

Disconnect the Ribbon Cable

1. Ribbon Cable Connector

3. Support for Cover

2. Ribbon Cable

Release Ribbon Cable

1. Ribbon Cable Connector Tabs
(Push tabs away from connector to release
cable then slide cable out of connector)

Note: Connector works same at both ends of the ribbon cable.

Reconnecting Ribbon Cable

1. Ribbon Cable Connector Release Tabs
(Slide cable into connector then push tabs
back into connector)

Note: Connector same at both ends of the ribbon cable.