JLG SSV10 Operator Manual User Manual

Page 72

SECTION 3 - MACHINE OPERATION

3-44

– JLG Lift –

3121186

Removing a Rug

This section describes the use of the Rug Carrier accessory in
removing a rug from a horizontal pivoting arm display rack.

1. Select the intended location in the display for removal of the

rug. Open the display rack to provide adequate space for
the lift and rug.

2. With the Rug Carrier Accessory arms stowed, drive the lift

into position prior to loading the rug.

3. Swing and lock the Rug Carrier Accessory arms into the

carry position.

4. Elevate the platform a few feet. Start to roll the rug onto the

Rug Carrier Accessory arms.

5. Be certain the rug is centered over its length on the Rug Car-

rier Accessory.

6. While elevating to the required height for removing the rug

from the display arm, continue to roll the rug until it is com-
pletely rolled up on the carrier arms.

7. Properly remove the rug from the display arm. Never climb

onto the platform rails for any reason.

8. After adequately removing the rug from the display arm,

lower the platform.

1. Rear Arm in Stowed Position
2. Rear Arm in Carry Position

3. Lift Arm, Swing Out and

Lower Down to Lock in Place