JLG SSV10 Operator Manual - Manual (Page 25)

SECTION 2 - PREPARATION AND INSPECTION
3121186 – JLG Lift – 2-7
Walk-Around Inspection Components
Reference - Figure 2-1. on page 2-6
NOTE: On all components, make sure there are no loose or miss-
ing parts, they are securely fastened, no visible damage,
leaks or excessive wear exists in addition to any other cri-
teria mentioned.
1. Front Caster Wheels - Check for any debris stuck to or
around wheels.
2. Base Frame - Check for loose wires or cables dangling
below the base.
3. Batteries (one each side of machine) - Not leaking; bat-
tery cables secure to posts; no corrosion.
4. Rear Drive Wheels - Check for any debris stuck to or
around wheels.
5. Mast Assembly - Mast sections; slide pads; mast
chains; sequencing cables; platform control and power
cables (on side of mast); power cables properly ten-
sioned and seated in sheaves; cable sheaves rotating
freely.
6. Motor/Pump/Reservoir Unit - No evidence of hydraulic
leaks. Hydraulic oil level should be filled level with the
full line on the dip stick.
7. Ground Control Station - Main Power Switch (Key)
operable; placards secure and legible; emergency stop
switch operates properly.
8. Manual Descent Control Valve - See note before item-
1.
9. Platform Control Console - Platform control; placards
secure and legible; emergency stop switch reset for
operation; Control markings legible.
10. Platform Assembly and Gate - Platform railings; entry
gate in proper working order, closing properly.
SECTION 2 - PREPARATION AND INSPECTION
3121186 – JLG Lift – 2-7
Walk-Around Inspection Components
Reference - Figure 2-1. on page 2-6
NOTE: On all components, make sure there are no loose or miss-
ing parts, they are securely fastened, no visible damage,
leaks or excessive wear exists in addition to any other cri-
teria mentioned.
1. Front Caster Wheels - Check for any debris stuck to or
around wheels.
2. Base Frame - Check for loose wires or cables dangling
below the base.
3. Batteries (one each side of machine) - Not leaking; bat-
tery cables secure to posts; no corrosion.
4. Rear Drive Wheels - Check for any debris stuck to or
around wheels.
5. Mast Assembly - Mast sections; slide pads; mast
chains; sequencing cables; platform control and power
cables (on side of mast); power cables properly ten-
sioned and seated in sheaves; cable sheaves rotating
freely.
6. Motor/Pump/Reservoir Unit - No evidence of hydraulic
leaks. Hydraulic oil level should be filled level with the
full line on the dip stick.
7. Ground Control Station - Main Power Switch (Key)
operable; placards secure and legible; emergency stop
switch operates properly.
8. Manual Descent Control Valve - See note before item-
1.
9. Platform Control Console - Platform control; placards
secure and legible; emergency stop switch reset for
operation; Control markings legible.
10. Platform Assembly and Gate - Platform railings; entry
gate in proper working order, closing properly.