JLG SSV10 Operator Manual - Manual (Page 23)

SECTION 2 - PREPARATION AND INSPECTION
3121186 – JLG Lift – 2-5
7. Function Check – Check all machine controls for oper-
ation. (See Section 2.5 on page 2-8)
If optional equipment is installed on this machine refer to Section 3
for specific Pre-Start Inspection and Operation instructions.
2.4 DAILY WALK-AROUND INSPECTION
Begin the “Walk-Around Inspection” at item one (1) as noted on
the diagram (See Figure 2-1. on page 2-6). Continue around
machine checking each item in sequence for the conditions listed
in the following check list.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS “OFF”
DURING “WALK-AROUND INSPECTION”.
DO NOT OPERATE MACHINE UNTIL ALL MALFUNCTIONS HAVE BEEN
CORRECTED.
IMPORTANT
DO NOT OVERLOOK VISUAL INSPECTION OF THE BASE FRAME
UNDERSIDE. CHECK THIS AREA FOR OBJECTS OR DEBRIS WHICH
COULD CAUSE EXTENSIVE MACHINE DAMAGE.
SECTION 2 - PREPARATION AND INSPECTION
3121186 – JLG Lift – 2-5
7. Function Check – Check all machine controls for oper-
ation. (See Section 2.5 on page 2-8)
If optional equipment is installed on this machine refer to Section 3
for specific Pre-Start Inspection and Operation instructions.
2.4 DAILY WALK-AROUND INSPECTION
Begin the “Walk-Around Inspection” at item one (1) as noted on
the diagram (See Figure 2-1. on page 2-6). Continue around
machine checking each item in sequence for the conditions listed
in the following check list.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS “OFF”
DURING “WALK-AROUND INSPECTION”.
DO NOT OPERATE MACHINE UNTIL ALL MALFUNCTIONS HAVE BEEN
CORRECTED.
IMPORTANT
DO NOT OVERLOOK VISUAL INSPECTION OF THE BASE FRAME
UNDERSIDE. CHECK THIS AREA FOR OBJECTS OR DEBRIS WHICH
COULD CAUSE EXTENSIVE MACHINE DAMAGE.