JLG 80H ANSI Parts Manual - Manual (Page 253)

3120272 2-163
S
E
C
T
I
O
N
2
T
U
R
N
T
A
B
L
E
SECTION 2 TURNTABLE
251 Cap and Breather Options: 1
1120287
Prior to July 1986
1340045 July 1986 to Present
252 Lid Options: 1
4842375 Prior to July 1986
1670468
July 1986 to Present
253 Gasket Options: 1
0100009 Prior to July 1986
3960371
July 1986 to Present
254
Not Used
255 2180399 Fitting, Coupling (Machines with Heaters Built July
1986 to Present Only) 2
256
2180398
Fitting, Coupling (Machines with Heaters Built July
1986 to Present Only) 1
257 2180053 Nipple (Prior to July 1986 Only) 1
HEATERS AND CONTROLS INSTALLATION Ref.
0236874
Prior To March 1988 Ref. G
0238777 March 1988 To Present Ref. D
301
1600043
Control, Thermoswitch 1
302
2580018
Heater, Immersion 2
303 0231756 Junction Box Assembly (See Items 401-403 for
Breakdown) 2
304 3311401 Nut 1/4"-20NC 4
305
4761400
Lockwasher 4
306 4300031 Stud (Welded on Part) 4
307 3251836 Nameplate - Engine/Battery Manifold Heater (Left
Box) 1
308
3251272
Nameplate - Hydraulic Oil Tank Heater (Right Box) 1
309 3251243 Nameplate - 120V-60Hz 2
0231756 JUNCTION BOX ASSEMBLY Ref. C
401 4460137 Receptacle, Female (1 Per Assembly) 1
4460082 Receptacle, Male (1 Per Assembly) 1
402
4460007
Strip, Terminal (1 Per Assembly) 1
403
4460049
Connector, Strain Relief (3 Per Assembly) 3
0255869 FUEL FILL EXTENSION KIT Ref. A
Note: For use on fuel tanks built prior to June
1995. Tanks built June 1995 to present are
already equipped with extension.
501 4845158 Fill Tube Extension Weldment 1
502
3960465
Seal 1
FIGURE 2-41. TANKS INSTALLATION (CONTINUED)
FIG & ITEM # PART NUMBER DESCRIPTION QTY. REV.