JLG X700AJ Operator Manual - Manual (Page 54)

SECTION 4 - MACHINE OPERATION
4-8 – JLG Lift – 3128790
Jib Position for Travelling
It is necessary to raise the JIB arm when driving up or down
slopes that exceed 10° and but less than the max. 25° to pre-
vent the jib from contacting the ground.
ONLY PERFORM THIS OPERATION WHEN IT IS NECESSARY. IN ALL
OTHER SITUATIONS, DRIVE WITH THE BOOM AND JIB FULLY LOW-
ERED AND ALIGNED.
The permission to use the JIB is indicated by
the icon in position 5 on the remote control
display panel.
Before lifting the jib arm in the traversing
phase, the following conditions must be veri-
fied:
• All outriggers must be lifted from the ground
• There must be no operator in the basket
• The platform/remote control box must be removed from
the platform and used from the ground.
NOTE: The aerial part safety device by-pass key must not
have been activated after the machine has been
closed and aligned.
If any of these conditions have not been met, the use of the JIB
is not possible and one of the following error displays appears.