JLG X700AJ Operator Manual - Manual (Page 115)

SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
3128790 – JLG Lift – 6-19
6.4 PLATFORM/REMOTE CONTROL SERVICE MENU
Service Button
A SERVICE button is present on the remote control which
allows to view the status of the machine parameters and is an
aid in the safety checks of the machine.
By pressing the SERVICE button a numerical menu is dis-
played on the LCD display, each of these menu items can be
accessed by pressing the corresponding platform/remote
control buttons (numbered 1 thru 9) below the buttons.
1 - INPUT
2 - LANGUAGE
3 - ERRORS
4 - RAMPS
5 - CURRENT
6 - W. HOURS
7 - SETUP
8 - JOYSTICK
9 - EXIT
MENUS 4; 5; CANNOT BE ACCESSED
Menu Input
The signals that arrive at the board from the various sensors
mounted on the machine and from the platform/remote con-
trol commands are displayed. The status of the input and the
following selection to scroll the menu appears for each
screen:
1 - PREV - access the previous input
2 - NEXT - access the successive input
9 - ESC - escape from the INPUT menu
LIGHTLIFT SELF-PROPELLED AERIAL PLATFORM - X700AJ
ST1 GND A
Both ON indicate the stabilizer 1 rests on the ground.
ST1 GND B
ST2 GND A
Both ON indicate the stabilizer 2 rests on the ground.
ST2 GND B
ST3 GND A
Both ON indicate the stabilizer 3 rests on the ground.
ST3 GND B
ST4 GND A
Both ON indicate the stabilizer 4 rests on the ground.
ST4 GND B
ST1 OPEN A
Both ON indicate the stabilizer 1 is completely open,
TOTAL AREA.
ST1 OPEN B