JLG X700AJ Operator Manual - Manual (Page 36)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3-6 – JLG Lift – 3128790
4. To remove the control station assembly, reverse the three
steps above.
NOTE: The Platform/Remote control box may also be used to
operate the tracks, outriggers and track widening (if
equipped) by removing it from the platform while still
connected to the flex cable. All boom functions will be
disabled when the platform/remote box is operated in
this manner.
Platform/Remote Control Station Functions
Footswitch (see photo below)
To operate any function, the footswitch must be
depressed and a function selected within seven sec-
onds. If a function is not selected within seven seconds,
or if a seven second lapse between ending one function
and beginning the next function, the footswitch must be
released and depressed again to enable the controls.