Eppendorf epMotion 5070 - Manual (Page 63)

Operation
epMotion ® 5070
English (EN)
63
9.2 Loading the worktable
To prepare the epMotion for an application, perform the following steps:
• Display the loading in the software
• Positioning tools
• epT.I.P.S. Motion
• Position the waste container
• Position labware
9.2.1 Display the loading
To display the loading of the worktable, proceed as follows.
1. Open the application.
2. Select the area or the Run (refer to epMotion software operating manual) step.
Abb. 9-1: Overview of tools and labware on the worktable
Fig. 9-1: Overview of tools and labware on the worktable
The epBlue worktable displays the required equipping of the epMotion worktable graphically.
3. Equip the epMotion worktable as displayed.
Details on equipping can be found in the following chapters.
NOTICE! Tool collisions with incorrectly positioned labware.
Labware must be positioned on the epMotion worktable as defined in the application.
Tools and labware become damaged in a collision. A collision can lead to sample loss.
 Check the positioning of the labware before starting the application.
50 50