IKA C 7000 Grundausstattung Set 2 - Manual (Page 64)

0HVVDJHV DQG 7URXEOHVKRRWLQJ
IKA  -WERKE C 7000 Ver. 07 09.07
3DJH
0HVVDJH &DXVH 5HPHG\
QR LQFUHDVH LQ WHPSHUDWXUH 12 seconds after the start of the
main test, the temperature
increase is less than 0.2 K.
Faulty ignition or vessel not filled
with oxygen.
Open vessel and check these points.
If the sample has burnt, the sample
was too small. Then increase size of
sample.
PHDVXUHPHQW UDQJH
H[FHHGHG
During a measurement, the
permissible temperature has
been exceeded.
Contacts of the decomposition
vessel (contact board) or the
calorimeters (contact pins) dirty
or damaged.
Measurement PCB defective.
Reduce mass of sample.
Clean contacts, if damaged inform
Technical Service Department.
Inform Technical Service
Department.
PHDVXUHPHQW FDUG
GHIHFWLYH
Hardware fault on measurement
PCB
Inform Technical Service
Department.
PHDVXUHPHQW DOUHDG\
SHUIRUPHG
A sample code has been entered
for which a temperature increase
is already stored (by
measurement or manually).
Enter sample code that has not yet
been used.
0HDVXUHPHQW VWDUWHG This indicates the start of a
measurement.
SRVWWHVW SDUDPHWHUV
DOUHDG\ HQWHUHG
Under this sample code, post-
test parameters are already
entered.
To change parameters, you can use
sub-menu HGLW in PHQX .
QR PHDVXUHPHQW
SHUIRUPHG \HW
Post-test parameters can only be
entered after a test has been
made.
First carry out measurement or enter
temperature increase manually.
VDPSOH FRGH LV DVVLJQHG Under this sample code,
parameters are already entered.
Enter sample code that has not yet
been used.
VDPSOH FRGH QRW IRXQG The sample code entered could
not be found.
Enter valid sample code.
PHPRU\ IRU WHVWV IXOO The available memory is full
(100 tests).
Erase tests no longer needed
( PHQX , sub-menu GHO ).