IKA C 7000 Grundausstattung Set 2 - Manual (Page 27)

IKA  -WERKE C 7000 Ver. 07 09.07
3DJH
&RPPLVVLRQLQJ
Once the components of the C 7000 calorimeter have been unpacked and brought
to the location chosen for the instrument (see Chapter 3, Section 3.2 "Installation
Location"), the mains lead and peripherals can be connected.
&RQQHFWLQJ WKH PDLQV OHDG
Check that the voltage given on the typeplate of the calorimeter corresponds to your
mains supply, then plug the mains lead into the socket on the rear of the calorimeter
and to the mains socket.
&RQQHFWLQJ SHULSKHUDOV
:KHQ FRQQHFWLQJ SHULSKHUDOV WKH PDLQV VZLWFK RI WKH FDORULPHWHU PXVW EH
VZLWFKHG RII
)RU DOO FRQQHFWLRQV WR WKH FDORULPHWHU XVH RQO\ WKH LQWHUIDFH FDEOHV VXSSOLHG
E\ ,.$
&RQQHFWLQJ D EDODQFH SULQWHU RU 3&
For connection of a balance, a printer or an external PC, there are sockets on the
rear of the unit marked %DODQFH , 3ULQWHU and 3& (see Section 4.1, illustration
C 7000 Rear view).
Now connect the peripherals you will be using.
&RQQHFWLQJ WKH FRROHU &
Connect the C 7002 cooler as follows:
c
Check that the voltage given on the typeplate of the cooler corresponds to your
mains supply, then plug the mains lead into the socket on the cooler and to the
mains socket.
d
There are two hoses with quick-connect couplings included with the cooler. Connect
them to the ,Q and 2XW connections on the rear of the cooler.
e
Connect the other end of the feed hose ( ,Q ) to a water supply, water tap or to a
cooling water supply (e.g. IKA  KV 500) and secure the connection. Take the drain
hose ( 2XW ) to a suitable sink and secure it there.
f
Use the cable provided to connect the cooler and calorimeter at the appropriate
sockets on the rear of each unit (see Chapter 4 "Description of System Compo-
nents").
The C 7002 cooler is now connected to the C 7000 calorimeter.