IKA C 7000 Grundausstattung Set 2 - Manual (Page 56)

(YDOXDWLRQ RI &DORULILF 9DOXH 7HVWV
IKA  -WERKE C 7000 Ver. 07 09.07
3DJH
([DPSOH selection of all test data for the month of December in the year 2000:
• the selection criterion for the date is " 1200". In this way, all the days of the
month, the 12 th . month, and the year 2000 will be selected;
• the selection criterion for the sample code is " ", so that the sample codes of all
the tests stored in the instrument will be selected;
• the selection criterion for the sample status is DOO so that, as before, all the tests
stored in the instrument will be selected.
3ULQWLQJ D WDEXODU VXPPDU\ RI WHVWV
By taking the following steps, you can print a tabular summary of all tests stored in
the instrument:
c
Make sure that the printer is connected and switched on.
d
Change from PHQX to the sub-menu RXWSXW by pressing the function button I , and
then use function button I to select the sub-menu WDEOH
e
Enter selection criteria for the date, sample code and sample status as described
above, and close your entries by pressing the PHP button. The printer will now start
to print.
The print-out has six columns:
• VDPSOH FRGH sample code, under which all data for the test are stored
• %1R number of the decomposition vessel used for the test
• GDWH date on which the test was carried out
• P >J@ sample mass in grams
• +R >-J@ gross calorific value in Joules per gram
• +X >-J@ net calorific value in Joules per gram
If no post-test parameters have been entered (see Section 8.2), the remark 37 SD
UDPHWHUV PLVVLQJ will be printed instead of the net calorific value; The net calorific
value can only be calculated with the aid of post-test parameters. If pre-test pa-
rameters have been entered but a test not yet carried out, the remark QR PHDVXUH
PHQW SHUIRUPHG \HW will be printed.
At the end of the summary of tests, the C values of the decomposition vessels will
be printed. If a decomposition vessel has not been calibrated, or if the data were
entered manually, this is indicated.
,QIRUPDWLRQ DERXW IUHH PHPRU\
The calorimeter can store a maximum of 100 tests. Using the following procedure,
you can find out at any time how much memory is still available for further tests.
c
Change from PHQX to the sub-menu RXWSXW by pressing the function button I , and
then use function button I to select the sub-menu IUHH . The message [ WHVWV IUHH
appears, where [ is the number of tests still free. An acoustic signal sounds at the
same time.
d
Acknowledge this message by pressing the
9
button.