Frame rail supported drivetrain jack – Advance Adapters 15-1000 User Manual
Page 4

ADVANCE ADAPTERS INC.
P/N: 15-1000
P.O. Box 247, 4320 Aerotech Center Way
New Item: (7/09)
Paso Robles, CA 93447
PAGE 4 OF 4
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
07-06-09
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
FRAME RAIL SUPPORTED
DRIVETRAIN JACK
universal hanger
"J" hanger
transmission
supports
jack assembly
jack support
locking pins
wing nuts
WARNINGS:
The Uni-raise is not a replacement for your stock crossmember. You can move a vehicle around by pushing
the vehicle while the Uni-Raise is installed, but the drivetrain should not be engaged under power.
While working under the vehicle with a Uni-Raise installed, use caution not to hit the jack system as it could
become disengaged from the drivetrain allowing the drivetrain to fall.
The Uni-Raise should not be used as an assembly that you can pry against as this can cause the jack
assembly to be disengaged from the drivetrain allowing the drivetrain to fall.