Frame rail supported drivetrain jack – Advance Adapters 15-1000 User Manual
Page 2

ADVANCE ADAPTERS INC.
P/N: 15-1000
P.O. Box 247, 4320 Aerotech Center Way
New Item: (7/09)
Paso Robles, CA 93447
PAGE 2 OF 4
Telephone: (800) 350-2223
Fax: (805) 238-4201
Page Rev. Date:
07-06-09
SPECIAL NOTE:
The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
FRAME RAIL SUPPORTED
DRIVETRAIN JACK
INSTALLATION NOTES:
The Uni-Raise is a frame rail supported drivetrain support system for trail repairs and drivetrain installations. The Uni-
Raise comes with two types of frame rail support options. The first is the "J" hanger. Most frame rails have a certain
amount of factory holes in the frame rails. The "J" hanger can be used in most of these frame holes. The second support
method is the universal hanger. If the jack needs to be placed in a location where no holes are in the frame, the universal
hanger loops over the frame rail. The universal hanger is usually a bit harder to install because of the fuel and brake
lines that may interfere on the frame rail. Vehicles without a body lift may also be a tight fit when installing the universal
hangers. All hangers must be installed either on the inside or outside of the frame rails and must be clear of brake lines
and fuel line and any other equipment that may be fastened to the frame rails. The hangers must have a good contact
to the frame as they will be supporting the weight of the drivetrain.
Once each hanger per side is installed to the frame rail, the hangers should be pointing towards the ground. The center
support and telescoping frame supports will need to be slid together and adjusted to the width of the hanger bolts on
the frame. Install the 1/4" locking pins to the center support to lock the telescoping frame support into position. Install
the support section onto the frame hangers fastening them to the hangers with a 1/2" flat washer and then the 1/2" wing
nut. The wing nut should be installed with at least 1" of thread through the nut.