Advance Adapters 15-1000 - Manual (Page 3)

ADVANCE ADAPTERS INC. P/N: 15-1000
P.O. Box 247, 4320 Aerotech Center Way New Item: (7/09)
Paso Robles, CA 93447 PAGE 3 OF 4
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 07-06-09
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
FRAME RAIL SUPPORTED
DRIVETRAIN JACK
Use the transmission jack support that best fits your transmission and install it to the jack assembly using the 1/4" locking
pin. Attach the jack assembly to the Uni-Raise support that is installed on your vehicle. The jack can slide right or left
on the support to be centered under the drivetrain. The wing nuts on the hanger bolts can be adjusted higher up the
hangers to get the jack closer to the transmission if needed.
Using a 5/8" wench or socket, adjust the jack up so that it comes in contact with the transmission. Double check the
jack's alignment to the drivetrain, making sure it is centered. Put a little tension on the jack upward to the drivetrain
and wiggle the entire assembly to make sure it is secure. If all is good and secure, you can now proceed to remove
the drivetrain crossmember. The Uni-Raise can be used to raise or lower the drivetrain as needed.