Advance Adapters KJ09156BK1 - Manual (Page 5)

15. After marking the holes, remove the bracket from the axle and drill
the 2 3/8 holes.
5. With the coil spring removed install the daystar lift spacer over the
stock spring isolator.
7. Install the coil springs on the driver side first then the passenger side and
jack up the axle to seat the springs and spacers.
8. Install the bushings, sleeves, and boots on the supplied longer shocks ab-
sorbers. Install the new shocks using the factory hardware.
9. Reinstall the sway bar links and ABS lines in their factory locations.
6. Pry out the factory bump stops and install the supplied bump stop extend-
ers in the factory cups. Then install the factory bump stops in the lower
end of the extenders. It may be necessary to lubricate the bump stops to
fully seat them in the extenders.