beautypg.com

Advance Adapters KJ09156BK1 User Manual

Page 3

background image

20. Remove the stock bump stops and install the bump stop extenders,

then install the stock bump stop into the extender as done on the
front installation.

21.

With the coil removed , install the rear lift spacer over the stock
spring isolator and re-install the coil spring.

22. Install the bushings, sleeves, and shock boots on the supplied Day-

star shocks absorbers.

23. Install the new longer Daystar shocks at the top first and jack up the

axle to connect the lower mounting. Use the factory hardware.

24. On each side, reconnect the brake line brackets to the frame.
25. Install the rear sway bar drop down bracket .
26. Place the supplied bracket between the stock sway bar bracket

bracket and the frame.

27. Place the 2 short sleeves into the bracket as shown..
28. Install the 2 longer 10mm x 60mm bolts with washers and loctite,

tighten the bolts.

Installation steps

1.

Jack up the front of the vehicle and support the vehicle at the frame with
jack stands. Put wheel chocks behind the rear tires.




















2.

With the jack under the front axle, jack up the axle to remove the driver
side and the passenger side wheels and disconnect the sway bar end link on
the driver side then the passenger side.