Advance Adapters SATURN - Manual

KIT CONSISTS OF:
No. Qty Part No. Description
ADVANCE ADAPTERS INC. P/N: SATURN
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 10
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 08-05-10
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we
strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
1. 1 GEAR ASSEMBLY (29 or 26 Tooth)
2. 1 HOUSING ASSEMBLY
3. 1 911806 SPECIAL TABBED LOCK WASHER
4. 1 911236 SPECIAL SNAP RING
5. 1 911137 BODY GASKET
6. 1 911133 OIL SCOOP
7. 5 911157 SEAL WASHERS
8. 5 911144 H.H.C.S. 3/8"-16 x 3-1/2" LG.
One of the most critical factors in performing a successful Saturn Overdrive installation, is the proper installation of the
tabbed washer and special snap ring. If these are not properly installed, the overdrive assembly can slip out of position
and cause gear damage that is not covered by warranty.
The second most important part of the installation is the proper alignment of the brass synchro ring onto the synchronizer
assembly. Advance Adapters has installed the brass ring onto the synchro assembly by use of some heavy wheel bearing
grease. This extra grease will maintain the proper location of the synchro ring while being installed onto the gear assembly.
If there are any questions as you are performing this installation, please do not hesitate to call the factory for assistance.
The third most important part of the installation the oil supply, The oil scoop is the only way oil is fed to the bearings in
the Saturn OD. We have seen units completely destroyed after just a 50 miles because the oil scoop was left off the unit.
SATURN OVERDRIVE ASSEMBLY