Advance Adapters 7155710 - Manual (Page 4)

Twin sticks through modified hole in floor.
Finished installation
ADVANCE ADAPTERS INC. P/N: 715571
P.O. Box 247, 4320 Aerotech Center Way New Item: (8/02)
Paso Robles, CA 93447 PAGE 4 OF 5
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 09-18-02
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
TOYOTA L/C TRANSFER CASE TWIN STICK
After welding is complete, press the bushings (P/N FJ4404) into both shift blocks until they are completely seated in both
the pivot block holes. This would be the best time to paint the two welded handle assemblies. Make sure to mask off the
bushings (FJ4404) so that no paint gets into the inside diameter. Now assemble the pivot shaft (P/N 715579), both handles
(715586 & 715587), the 5-16" flat washer, the 5/16" lock washer, and the 5/16"-18 nut together as a unit. Push the handles
up through the floor and thread the pivot shaft into the side of the transmission.
Now install the two 3/8" jam nuts and ball joints onto the 3/8" all thread and bolt this assembly to the high/low shift handle
and arm. Adjust the length so that the handle is pointing straight up when the transfer case is in neutral. Cutting of the all
thread may necessary to achieve this. Repeat this same process for
the mode shifter assembly using the ball joint, jam nut, and male heim
joint. The male heim joint mounts to the mode shaft with the supplied
clevis pin and cotter pin.
Once the transfer case shifts in a satisfactory manner, mount the shift
boot over the hole in the floor using the metal ring supplied. Use
approximately 4 self tapping screws to go through the boot, metal
ring, and floor. Finish the installation by adding the 1/2" jam nuts and
the shift knobs.