beautypg.com

Toyota l/c transfer case twin stick – Advance Adapters 7155710 User Manual

Page 2

background image

715575

715577

715581

715585

715576

715579

FJ4404

(4 PLCS.)

715587A

7155876A

715588

715584

715583

715582

715580

(2 PLCS.)

ADVANCE ADAPTERS INC.

P/N: 715571

P.O. Box 247, 4320 Aerotech Center Way

New Item: (8/02)

Paso Robles, CA 93447

PAGE 2 OF 5

Telephone: (800) 350-2223

Fax: (805) 238-4201

Page Rev. Date:

10-04-06

SPECIAL NOTE:

The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will

void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.

TOYOTA L/C TRANSFER CASE TWIN STICK

shift fork bolt

detent ball and spring

INSTALLATION OF PART #715585:

This kit requires the installation of a new mode selector shaft into your stock transfer
case. This shaft can be installed with the transfer case still in the vehicle. The mode
shaft is installed into an aluminum housing that is bolted to the front output shaft
housing of the transfer case. This mode shaft housing bolts on using (4) 12mm bolts.
By removing these bolts, the mode housing can be removed from the transfer case.
Set the mode housing on a bench and remove the plug bolt to expose the bolt that
couples the shift fork to the mode shaft. Remove the shift fork bolt through this

access hole. Remove the shifter detent ball and
spring by removing the detent bolt. Remove the
rubber boot from the mode housing and pull the
mode shaft from the housing. Install the new mode shaft through the seal and into
the housing with the detent notches in the correct orientation. Reinstall the shift fork
bolt into the shift fork and new mode shaft. Insert the detent ball, spring and cap into
the housing. Slide the rubber boot back onto the mode shaft. Install the mode housing
back onto the transfer case, making sure to silicone between the surfaces to secure
for no leaks.