Advance Adapters 303020A - Manual (Page 9)

ADVANCE ADAPTERS INC. P/N: 303020
P.O. Box 247, 4320 Aerotech Center Way New Item: (2/08)
Paso Robles, CA 93447 PAGE 9 OF 9
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 06-07-13
ATLAS T/C JEEP TJ & (XJ 84-01)
CABLE SHIFTER
The Igus bushings must be pressed into the shift handle. A arbor press or a light hand with a hammer works well. Once the
bushings are installed the pivot pin gets installed through the handle.
Install the pin mounts. (note these photos show a assembly of a simular kit that uses the same mounting hardware but
different handles)
Once both pivot pin mounts are installed, use the #6 set screws to lock them to the pivot pin. The pivot pin should be
flush with the outside edge of the pin mounts. Install the handle assembly into the shifter housing making sure the
handles are pointing forward or in the same direction as where the cable will be mounted (see photo). Secure the pivot pin
mounts to the shifter housing using 3 of the B.H.C.S and the one S.H.C.S.