Advance Adapters 303020A - Manual (Page 3)

SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We
recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally
available at automotive dealerships and parts stores.
ADVANCE ADAPTERS INC. P/N: 303020A
P.O. Box 247, 4320 Aerotech Center Way New Item: (2/08)
Paso Robles, CA 93447 PAGE 3 OF 9
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 04-24-12
ATLAS TRANSFER CASE JEEP TJ
CABLE SHIFTER
1. For Jeeps with factory automatic transmission the first
step is to remove the shift buttom/spring detent assem-
bly from the shifter handle. This can be done by using
a small flat head screw driver to "pry off" the shift
button end cap. To remove the handle, firmly grab and
pull up until it releases from the shift lever.
2 . Using the same flat head screw driver, remove the
factory shift indicator assembly from the console.
Carefully remove indicator light bulb assembly and set
aside.
3 . Depending on console style, you may have up to five
bolts securing the console. Two piece consoles only
require removal of two or possibly three bolts. One is
located in the front cup holder possibly under the rubber
insert. The second is found just to the right of the
transmission shift lever. Although uncommon, a third
bolt or plastic push pin is sometimes found on the front
of the console under the carpet.
4 . Maneuver the console so that the stock transfer case
shift lever slips through the slot in the console. Remove
console and set aside for later.
5 . Remove five mounting bolts securing the stock transfer
case shifter mount and save for later. These bolts will
sometimes be hard to remove because of corrosion in
the threads. Prior to removal, spray threads with a
thread lubricant. This step will ensure that the threads
of the factory "nut-serts" remain undamaged for instal-
lation of new shifter assembly.
6 . With the five mounting bolts removed, pull the shifter
assembly out of the floor far enough to access the nut.
NOTE: If the stock shifter bolts are missing or have been discarded. Replace with five 10-32" X .625" bolts
or screws and washers.
NOTE: Refer to factory service manual for detailed disassembly instructions