Advance Adapters 303020A - Manual (Page 5)

Remove the 1/4" jam nut and
install the nut cap over the cable.
Install the cable nut on the cable
threads.
The cable should bottom out in
the shift rail and the cable nut
should be flush against the face of
the shift rail.
Once the cable nut has been adjusted, slide the nut cap over the shift rail
and tighten to retain the cable to the shift rail. Shift the transfer case into
low range (shift rail pushed inward) to set the outer cable housing.
The outer cable housing now needs
to be set. Pull the outer housing
away from the transfer case. The in-
ner cable should be fully extended.
With the cable fully extended in this direction you will now
need to secure the 5/8" jam nuts to the bracket of the transfer
case. Since the cable has a bit more travel than the Atlas
needs, we recommend to thread on (circled) nut first to the
bracket and then give it one addition full turn which will pull the outer cable housing back slightly. Then snug the
front nut. Once both nuts are snug to the bracket, tighten them with a wrench. Before moving up to the shifter box,
shift transfer case back to neutral.
ADVANCE ADAPTERS INC. P/N: 303020A
P.O. Box 247, 4320 Aerotech Center Way New Item: (2/08)
Paso Robles, CA 93447 PAGE 5 OF 9
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 04-24-12
ATLAS T/C JEEP TJ & (XJ 84-01)
CABLE SHIFTER