Advance Adapters 303009A - Manual (Page 4)

5 . Slide the cables into the back of the shifter body.
6 . Orient the shifter handles so they bend away from each other, and slide the handles into the top of the
shifter body.
7 . Insert the pivot shoulder bolt through the shifter body and the shifter handles. Fasten with the 1/4" flat
washer and the 5/16" locknut.
8 . Slide the heim joint meet the tapped hole in the shift handle and insert the bolt from the bottom of the shifter
box to secure the handles to the cables.
9 . Slide the cable barrel retainer plate up the shifter body and fasten it with the 1/4"-20 button head cap
screws.
9 . First adjust the cables with the adjustment on the transfer case end by changing the position of the two
5/8" jam nuts. Fine tuning of the adjustment can be done from the passenger compartment of the vehicle
with the shifter assembled in the following manner. Loosen the cable barrel retainer plate and the shift
cable 5/8" jam nuts. By rotating the cable barrel in either direction, the cable adjustment will change. The
twin stick handles should be straight up and down within the shifter body while the Atlas is in neutral.
When the shifter is adjusted properly, tighten the jam nuts and the cable barrel retainer plate screws.
10. Slide the shift boot over the handles and
stretch it over the shifter body. Depending
on how the shifter is mounted, you may want
to bolt the shift boot through the shifter
body. If the shifter will be flush mounted in
the floor, you may bolt through the shift
boot, shifter body, and the floor with one set
of bolts.
12. Once the boot is in place, thread the 1/2"-13
jam nuts, and then thread the shift knobs
onto the shifter handles.
ATLAS TRANSFER CASE CABLE SHIFTER
SOLD WITHOUT AN ATLAS
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the
components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion,
we strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
ADVANCE ADAPTERS INC. P/N: 303009A
P.O. Box 247, 4320 Aerotech Center Way New Item: (05/04)
Paso Robles, CA 93447 PAGE 4 OF 5
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 06-29-11
*Note: The first cable shifters used an shift rail adapter on the
shift rail for coupling the cables to the Atlas. The shift rails
were changed 7-1-07. This new style of rail is drilled and
tapped to directly accept the threaded cable end and eliminate
the shift rail adapter. We switched back to the adapters
fittings 8-16-10 for ease of installation of the cable to the
Atlas. Some shift rails still have the thread on the end of the
shift rail.