Snorkel ATB50 CE - Manual (Page 14)

u
Fuel Handling Precautions
DO NOT smoke or permit open flames while
fueling or near fueling operations.
Never remove the fuel cap or refuel a gasoline
engine while the engine is running or hot. Never
allow fuel to spill on hot machine components.
Maintain control of the fuel filler nozzle when
filling the tank.
DO NOT fill the fuel tank to capacity. Allow room
for expansion.
Clean up spilled fuel immediately.
Tighten the fuel tank cap securely. If the fuel cap
is lost, replace it with an approved cap from
Snorkel. Use of a non-approved cap without
proper venting may result in pressurization of the
tank.
Never use fuel for cleaning purposes.
For diesel engines, use the correct fuel grade for
the operating season.
s
Safety Placards and Decals
There are several safety placards and decals on
the ATB 42/50. Their locations and descriptions
are shown in this section. Take time to study
them.
A
CAUTION
Be sure that all the placards and decals on the
ATB 42/50 are legible. Clean or replace them
if you cannot read the words or see the
pictures. Clean with soap & water and a soft
cloth. Do not use solvents.
You MUST replace a placard or decal if it is
damaged, missing, or cannot be read. If it is
on a part that is replaced, make sure a new
decal or placard is installed on the replaced
part. See your Snorkel dealer for new decals
and placards.
NOTE
Refer to Placards and Decals in the “Daily
Inspection and Maintenance” chapter 7, for
part numbers, location, and required quantities
of all placards and decals.
page 1 - 4 ATB 42/50 – 0161987EE
1. Safety