beautypg.com

Emergency operation, Emergency operation procedures 9-1, Operation from platform control box 9-1 – Snorkel AB50JRT User Manual

Page 74: Emergency operation, 9-1, Operation from platform control box, 9-1, Procedures, 9-1, Emergency operation procedures -1, Operation from platform control box -1, Danger

background image

4. Enter the platform and attach the lanyard of

your fall restraint to the lanyard anchor point
(4) on the platform.

5. Use the controls on the platform control box

(5) to raise the jib boom (6) to its horizontal
position.

6. Use the platform controls to bring the AB50J

into the stowed position (except jib boom
horizontal) at the foot of the loading ramp (7)
with the steering wheels (8) nearest the ramp
(7).

7. Visually check (from the platform) to be sure

the AB50J is aligned with the ramp and the
ramp is still aligned with the truck or trailer.
All should be in a straight line.

Death or Serious Injury can result from
losing control of an AB50J while loading.
Always set the Drive Range to LOW before
you drive up or down a grade.

8. Set the Drive Range to LOW.

9. Use turntable Swing to move the platform

slightly to the side so you are aligned with the
wheels and can see them better.

10. Use the Drive/Steer controller to slowly drive

the AB50J straight onto the ramp and
transport trailer.

11. Use turntable Swing to align the main boom

between the rear wheels.

12. Lower the jib boom until it is completely

down.

13. Leave the engine running in preparation for

securing the machine to the transport
vehicle.

14. Chock the AB50J wheels.

Securing to a Transport Vehicle

This procedure assumes that you have just
finished loading the machine onto the transport
vehicle, that the AB50J engine is still running,
and that the wheels are chocked.

1. Use Main Boom Lift to raise the jib end

bracket (1) a few inches.

2. Toenail (2) a large wooden block (3) directly

below the jib end bracket (1).

3. Use Main Boom Lift to lower the jib end

bracket (1) onto the block (3).

4. Set the Anti-Restart switch to OFF.

5. Set the Master Key Switch to OFF then

remove the key.

DO NOT run a strap over the platform toe
board (6). The toe board is not strong enough
to hold the platform down and will be damaged
in transit. Run a strap where shown.

6. Tighten a nylon strap (4) over the mounting

bracket (5) as shown.

7. Set the Battery switch to OFF and lock it.

page 10 - 2

AB50J – 0163189

10. Stowing and Transporting

DANGER

DANGER