Snorkel AB50JRT - Manual (Page 46)

7. Daily Inspection and Maintenance
At the start of each work day (or 8 hour shift), an
AB50J qualified operator must perform the Daily
Inspection and Maintenance as listed in the table
below.
The purpose of the Daily Inspection and
Maintenance is to keep the AB50J in proper
working condition and to detect signs of
malfunction at the earliest possible time.
The AB50J should be in the STOWED POSITION
and the Master Key Switch set to OFF before
you begin this inspection.
Defective parts and/or equipment malfunctions
jeopardize the safety of the operator and other
personnel, and can cause damage to the
machine.
DO NOT operate an AB50J that is known to
be damaged or malfunctioning.
Repair all equipment damage or malfunctions,
before placing the AB50J into service.
AB50J – 0163189 page 7 - 1
Item Service Required
Engine fuel level Look to see that the fuel tank is full
Fuel tank cap Check to see that the cap is tight
Engine oil level Check oil level (between dipstick lines)
Fuel leaks Visually inspect (hoses and connections)
Engine coolant level Check fluid level and radiator hoses
Wiring harnesses Visually inspect (installation, condition)
Battery terminals Visually inspect (no corrosion)
Battery fluid level Check fluid level (1/4" or 6 mm below filler neck)
Hydraulic oil level Visually inspect level (between lines on gauge)
Hydraulic oil leaks Visually inspect (hoses, tubes)
Tires Visually inspect (condition)
Bolts and fasteners Visually inspect (condition)
Structural damage and welds Visually inspect (weld cracks, dents)
Lanyard anchor points Visually inspect (condition)
Platform gravity gate Check condition and operation
Platform swinging gate (option) Check condition and operation
Platform guardrails Visually inspect (condition)
Flashing lights (option) Visually inspect (operation)
Air filter Check condition (gauge)
Charging system Visually inspect (gauge)
Ground control switches and alarms Actuate and inspect for proper operation
Level sensor Check operation
Emergency power Check operation (causes correct motion)
Platform control box switches and
alarms Actuate and inspect for proper operation
Ground Fault Circuit Interrupt Check operation
Platform work lights (option) Check operation
Slide pads Visually inspect for installation and boom wear marks
Axle unlocked alarm, tipover hazard light Actuate and inspect for proper operation
Placards and decals Visually inspect (installation, condition)
■ Daily Inspection and Maintenance Table
DANGER