Bryan Boilers Triple-Flex High Efficiency Boilers & 300 - Manual (Page 39)

Date: 8-4-2010
Revision: 0
Form: 2396
33
323
Abnormal Recycle: Safety Relay off
after 10 seconds of RUN
324
Abnormal Recycle: Hardware flame
bias
325
Abnormal Recycle: Hardware static
flame
326
Abnormal Recycle: Hardware flame
current invalid
327
Abnormal Recycle: Hardware flame
rod short
328
Abnormal Recycle: Hardware invalid
power
329
Abnormal Recycle: Hardware invalid
AC line
330
Abnormal Recycle: Hardware SLO
flame ripple
331
Abnormal Recycle: Hardware SLO
flame sample
332
Abnormal Recycle: Hardware SLO
flame bias range
333
Abnormal Recycle: Hardware SLO
flame bias heat
334
Abnormal Recycle: Hardware SLO
spark stuck
335
Abnormal Recycle: Hardware SLO
spark changed
336
Abnormal Recycle: Hardware SLO
static flame
337
Abnormal Recycle: Hardware SLO
rod shorted
338
Abnormal Recycle: Hardware SLO
AD linearity
339
Abnormal Recycle: Hardware SLO
bias not set
340
Abnormal Recycle: Hardware SLO
bias shorted
341
Abnormal Recycle: Hardware SLO
electronics
342
Abnormal Recycle: Hardware
processor clock
343
Abnormal Recycle: Hardware AC
phase
344
Abnormal Recycle: Hardware A2D
mismatch
345
Abnormal Recycle: Hardware VSNSR
A2D
346
Abnormal Recycle: Hardware 28V
A2D
347
Abnormal Recycle: Hardware HFS
IAS shorted
348
Abnormal Recycle: Hardware PII
INTLK shorted
349
Abnormal Recycle: Hardware HFS
LCI shorted
350
Abnormal Recycle: Hardware HFS
LFS shorted
351
Abnormal Recycle: Invalid zero
crossing
352 Abnormal Recycle: fault stack sensor
353 Abnormal Recycle: stack limit
354 Abnormal Recycle: delta T limit
355 Abnormal Recycle: fault outlet sensor
356 Abnormal Recycle: outlet high limit
357 Abnormal Recycle: fault DHW sensor
358 Abnormal Recycle: DHW high limit
359 Abnormal Recycle: fault inlet sensor
360
Abnormal Recycle: Check
Parameters Failed
361
Internal error: No factory parameters
were detected in control
362
Internal error: PID iteration frequency
was invalid
363
Internal error: Demand-Rate interval
time was invalid
364
Internal error: Factory calibration
parameter for modulation was invalid
365
Internal error: CH PID P-scaler was
invalid
366
Internal error: CH PID I-scaler was
invalid
367
Internal error: CH PID D-scaler was
invalid
368
Internal error: DHW PID P-scaler was
invalid
369
Internal error: DHW PID I-scaler was
invalid
370
Internal error: DHW PID D-scaler was
invalid
371
Internal error: Lead Lag master PID
P-scaler was invalid
372
Internal error: Lead Lag master PID I-
scaler was invalid
373
Internal error: Lead Lag master PID
D-scaler was invalid
374-
459
RESERVED
460 LCI demand lost in run
461 Demand lost in run
462 STAT demand lost in run
463 Demand lost in run due to no flame
464-
466
RESERVED
467
Internal error: EEPROM write was
attempted before EEPROM was
initialized
468
Internal error: EEPROM cycle count
address was invalid