Synergy 8024-30/8024-40 - JK Synergy Stage 4 Long Arm System - Manual (Page 3)

Figure 4-1
b) The same brake line is used at all 4 corners, once the brake line is installed at the
caliper you can slightly bend the 90 bent tube end of the brake line at the caliper
toward the frame similar to the stock brake line.
Figure 4-2
c) Wait until the rear brake lines are installed to bleed the brakes.
5. REMOVE STOCK FRONT CONTROL ARM BRACKETS
a) Remove the stock upper and lower control arms. The exhaust on the passenger
side frame mount prevents the upper control arm bolt from being removed in one
piece. You will have to cut the head of the bolt off to remove the bolt. A sawzall
or grinder with a cut off wheel works well.
b) Cut off the inner part of the lower control arm bracket.