Synergy 8024-30/8024-40 - JK Synergy Stage 4 Long Arm System - Manual (Page 18)

e) Trim the bottom of the rear body mount. Leave about 1 1/8” from the top surface
of the body mount to cut edge.
f) Grind the welds and smooth where you removed the control arm brackets and
body mount. The side and bottom where the new control arm bracket is located
needs to be smooth, the inside of the frame and the upper control arm bracket do
not need to be completely cleaned off.
g) Remove the threaded insert for the gas tank bracket just in front of the lower
control arm bracket. Use the same procedure as in step 5-f.
h) Cut off the mounting tab on the gas tank skid that is located just in front of the
lower control arm bracket.