Synergy 8024-30/8024-40 - JK Synergy Stage 4 Long Arm System - Manual (Page 22)

19.
INSTALL LOWER CONTROL ARMS
a) Pre-preset the length of the lower control arms to 31 5/8”. Turn the Johnny joint
so that the grease fitting is adjacent to the adjuster pinch bolt.
b) Install the new control arms with the bend upward and inward. The bushing goes
at the axle end and the Johnny Joint goes at the frame end with the pinch bolt and
grease zerk on the top. Reuse the factory mounting bolts. Hand tighten the
control arm bolts, wait until the end of the installation and the jeep is sitting at
ride height before you torque these bolts.