Synergy 8024-30/8024-40 - JK Synergy Stage 4 Long Arm System User Manual
Page 16
Figure 17-1
b) The same brake line is used at all 4 corners, once the brake line is installed at the
caliper you can slightly bend the 90 bent tube end of the brake line at the caliper
toward the frame similar to the stock brake line.
Figure 17-2
c) You can now bleed the brake system.
18. REMOVE STOCK REAR CONTROL ARM BRACKETS
a) Remove the stock upper and lower control arms.
b) Remove the fuel tank. You must remove the fuel tank to remove the passenger
rear lower control arm bracket and to access the inner wall of the frame to install
one of the nut tabs. Refer to the factory service manual for the exact procedure.
c) Using a cut-off wheel, cut the sides of the lower control arm bracket as shown
below. Cut just below the welds on the frame. Be careful to not cut through the
frame. Cut the weld on the front of the control arm bracket on the bottom of the
frame.