Synergy 8025 - Jeep JK Synergy Stage 1.5 Suspension System - Manual (Page 6)

• Wait to torque the new cam bolt until the vehicle is on the ground.
6. BUMPSTOP SPACERS AND COIL SPRINGS
• Locate and center punch the center of the bump stops strike pad on the axle coil spring
mounts. Drill a 3/8” hole.
Figure 6-1
• Put the bump stop bolt though the bump stop and slide the bump stop into the bottom of
the coil spring.
• Install the coil spring while holding the bump stop spacer inside the coil spring.
When the spring is in place, align the bump stop spacer bolt with the hole that was
drilled. Install the bump stop bolt through the hole and the 3/8” serrated nut onto the
bump stop bolt. Hand tighten the nut and then use a 5/16” allen wrench through the coil
spring to tighten the bump stop bolt.