Synergy 8025 - Jeep JK Synergy Stage 1.5 Suspension System - Manual (Page 3)

• Remove the cam positioning tabs from the LCA mounts. You can purchase 8004-01 JK
Cam Bolt Knockout Tool or if you have the proper tools you can cut the tabs out.
• You will notice that the bolt hole in the LCA mount is square. There are partially
punched metal tabs at the front and back of the square hole; these tabs need to be
punched out to make the LCA mount slotted. Since you need to increase castor, only the
tabs that are toward the rear of the vehicle need to be punched out. The easiest way to
remove the tabs is to cut the top and bottom with a narrow saw blade (Figures
5-1 and 5-2), then bend/break the tabs out with pliers (Figure 5-3). You may need to
clean the burr from the back edge of the hole with a file or carbide burr for the cam
bolt/washer to fit (Figure 5-4). Do this to each side of both front LCA mounts. Total of
four places.
Figure 5-1