Lukas LH2 - Manual (Page 14)

14
6.4 2-way distribution valve
NOTE:
To mount the 2-way distribution valve, first the base plate without closing
screws, fittings and couplings has to be mounted.
1. Put the sealing rings and the 2-way
distribution valve onto the pump head, so
that the boreholes “T” and “P” of the 2-way
distribution valve matches with the ports of
the base plate / pump head.
Take care, that the surfaces are clean and
dust-free.
2. Put the 4 screws into the designated
boreholes and tighten them with a torque
of 32 Nm.
3. When you are connecting the hose assemblies directly to the hand pump, you will have
to mount appropriate designated couplings, fittings or closing screws to the ports “P” and
“T”. (tightening torque M
A
= 40 Nm)
ATTENTION!
After the end of the assembly close all hydraulic lines by using closing screws
and/or dust protection caps, to prevent the hand pump from impurities.