Apple PowerBook (2400c) - Manual (Page 100)

m Make sure you are using the correct cable for SCSI disk mode. The HDI-30
SCSI Disk Adapter is about 10 inches long, is dark gray, and has 30 pins in
the connector (no “missing” pins). Do not use the HDI-30 SCSI System
Cable, which is light gray, is about 18 inches long, and has 29 pins in the
connector (one “missing” pin). That cable is for connecting SCSI
equipment to your PowerBook.
m Check that all cable connections are secure.
m The PowerBook’s battery may be drained. Plug in the power adapter and
let the battery charge for a few minutes. Then press the Power key on the
PowerBook’s keyboard to restart it, and restart the other Macintosh.
m Start up the other Macintosh with the Disk Tools disk that came with it (do
not use the disk that came with your PowerBook). If the connection works,
then a system software extension on the other Macintosh may be causing
the problem.
When I start up using SCSI disk mode, I see a flashing question mark icon.
m Make sure you are using the correct cable for SCSI disk mode. The HDI-30
SCSI Disk Adapter is about 10 inches long, is dark gray, and has 30 pins in
the connector (no “missing” pins). Do not use the longer, light gray HDI-30
SCSI System Cable.
m Make sure terminators are placed correctly in the SCSI chain. For more
information, see “Connecting SCSI Devices” in Chapter 3.
The Macintosh I’m connected to in SCSI disk mode doesn’t see the PowerBook.
m You cannot use the PowerBook in SCSI disk mode if password protection
is turned on. Turn password protection off in the Password Security
control panel.
m Make sure you are using the correct cable for SCSI disk mode. The HDI-30
SCSI Disk Adapter is about 10 inches long, is dark gray, and has 30 pins in
the connector (no “missing” pins). Do not use the longer, light gray HDI-30
SCSI System Cable.
100 Chapter 6