AEM Infinity Supported Applications - Mitsubishi 1995-1999 4G63 Engine User Manual
Page 10
10
© 2014 AEM Performance Electronics
Infinity
Pin
Hardware
Reference
7100-XXXX-62
7101-XXXX-63
Function
Dest.
Pin
2G
DSM
Hardware Specification
Notes
C1-23
Digital_In_2
Camshaf t
Position
Sensor 2 Hall
90
10K pullup to 12V. Will work with
ground or f loating switches.
See Setup Wizard page Cam/Crank f or
options.
C1-24
Digital_In_3
Turbo Speed
Hz
10K pullup to 12V. Will work with
ground or f loating switches.
See Setup Wizard page Input Function
Assignment f or calibration constant.
TurboSpeed [RPM] = Turbo [Hz] * Turbo Speed
Calibration.
C1-25
Digital_In_4
Vehicle Speed
Sensor
86
10K pullup to 12V. Will work with
ground or f loating switches.
See Setup Wizard page Input Function
Assignment f or calibration constant.
C1-26
Digital_In_5
Flex Fuel
10K pullup to 12V. Will work with
ground or f loating switches.
See channel FlexDigitalIn [Hz] f or raw
f requency input data.
C1-27
Knock Sensor 1
Knock Sensor
1
78
Dedicated knock signal processor
See Setup Wizard page Knock Setup f or
options.
C1-28
Knock Sensor 2
Knock Sensor
2
Dedicated knock signal processor
See Setup Wizard page Knock Setup f or
options.
C1-29
+12V_Relay _Contr
ol
+12V Relay
Control
38
0.7A max ground sink f or external
relay control
Will activ ate at key on and at key of f
according to the conf iguration settings.
C1-30
Power Ground
Ground
13
Power Ground
Connect directly to battery ground.
C1-31
CANL_Aout
AEMNet
CANL
Dedicated High Speed CAN
Transceiv er
Recommend twisted pair (one twist per 2")
with terminating resistor. Contact AEM f or
additional inf ormation.
C1-32
CANH_Aout
AEMNet
CANH
Dedicated High Speed CAN
Transceiv er
Recommend twisted pair (one twist per 2")
with terminating resistor. Contact AEM f or
additional inf ormation.
C1-33
LowsideSwitch_1
Boost Control
11
Lowside switch, 4A max with
internal f ly back diode. Inductiv e
load should NOT hav e f ull time
power.
See Setup Wizard page Boost Control f or
options. Monitor BoostControl [%] channel f or
output state.
C1-34
Lowside Fuel Pump
driv e
Fuel Pump
8
Lowside switch, 4A max, NO
internal f ly back diode.
Switched ground. Will prime f or 2 seconds at
key on and activ ate if RPM > 0.
C1-35
Analog_In_7
Throttle
Position
Sensor
84
12 bit A/D, 100K pullup to 5V
0–5V analog signal. Use +5V Out pins as
power supply and Sensor Ground pins as the
low ref erence. Do not connect signals
ref erenced to +12V as this can permanently
damage the ECU. See the Setup Wizard Set
Throttle Range page f or automatic min/max
calibration. Monitor the Throttle [%] channel.
Also DB1_TPSA [%] f or DBW applications.