AEM 30-6600 Series 2 Plug & Play EMS - Manual (Page 6)

Application Notes for EMS P/N 30-6600
KA24DE, GA16DE, SR20DE, SR20DET
Make: Nissan/Infiniti Spare Injector Drivers: Inj 5, Pin 23
Model: 240SX, Sentra, Pulsar GTiR,
NX, Altima, Bluebird, G20 Spare Injector Drivers: Inj 6, Pin 105
Years Covered: 1989-1995 Spare Injector Drivers: Inj 7, Pin 14
Engine Displacement: 1.6L, 2.0L, 2.4L Spare Injector Drivers: Inj 8, Pin 114
Engine Configuration: Inline 4
Firing Order: 1-3-4-2 Spare Coil Drivers: Coil 2, Pin 7
N/A, S/C or T/C: N/A, T/C Spare Coil Drivers: Coil 3, Pin 5
Load Sensor Type: 0-5V MAF Spare Coil Drivers: Coil 4, Pin 25
Number of Coils: 1 (Distributor) Boost Solenoid: PW2, Pin 111
EGT #1 Location: Pin 8
EGT #2 Location: Pin 15
Ignition driver type: 0-5V Falling Edge trigger EGT #3 Location: Pin 44
Number of Injectors: 4 (P&H drivers: Inj 1-4) EGT #4 Location: Pin 115
Factory Injectors: 185cc - 444cc
Factory Inj Resistors: Pulsar GTiR only
Injection Mode: Sequential Spare 0-5V Input: MAP, Pin 35
Knock Sensors used: 1 Spare 0-5V Input: ADCR11, Pin 33
Lambda Sensors used: 1
Idle Motor Type: Duty-controlled solenoid Spare Low Side Driver: LS2, Pin 45
Main Relay Control: Yes (not user programmable) Spare Low Side Driver: LS4, Pin 102
Crank Pickup Type: Optical Spare Low Side Driver: LS5, Pin 10
Crank Teeth/Cycle: 24 (AEM trigger disc) Spare Low Side Driver: LS9, Pin 106
Cam Pickup Type: Optical Check Engine Light: LS10 , Pin 24
** Cam Teeth/Cycle: 1 (AEM trigger disc)
Transmissions Offered: Manual/Automatic Spare High Side Driver: HS1, Pin 28
Trans Supported: Manual only
Drive Options: FWD, RWD, AWD Spare Switch Input*: Switch 2, Pin 43
Supplied Connectors: N/A
AEM extension/patch
harness 30-2995 A/C Switch Input*: Switch 6, Pin 41
Wire View of AEM EMS
WARNING:
*All switch input pins must connect to ground; the switch should not provide 12V power to
the EMS because that will not be detected as on or off.
Page 6 of 12