AEM 30-3508 Infinity Plug & Play Harnesses - Honda 2000-2005 S2000 - Manual (Page 7)

2000–2005 Honda S2000 7
© 2014 AEM Performance Electronics
Step 3
Attach one side of the Velcro to the
back of the EMS and the other to the
chassis, as shown. Loosely screw the
OEM ECU bolt into the spare boss,
shown in red.
Attach the AEM 80-pin connector to the
EMS. Secure the Infinity connector by
sliding the red locking tab.
Slide the EMS all the way up until the
adapter harness contours around the top
side of the kick panel area. The OEM
ECU bolt should just be present on the
bottom side of the EMS.
Position the EMS onto the hook and
loop strip adhered to the chassis.
Step 4
Move the EMS so half of the OEM ECU
bolt’s washer locks onto the EMS
mounting tab’s outer edge, as shown.
Tighten this bolt.
Next, connect the three OEM Honda
ECU connectors to the Honda header
found in the AEM adapter. Connect the
included mini USB communication cable
to the EMS.
If there are to be any AEMnet devices
that will be daisy-chained to the Infinity
EMS, secure it to the AEM adapter’s 4P
Deutsch connector.